AUX
confirm arming. If no arm confirmation is received, the remote will give
the Out-Of-Range signal.
If errors are found when arming:
If an alarm trigger zone - such as a door, the trunk, the hood, or a
sensor, was active at the time of arming, the system will “ bypass” , or
ignore, this trigger zone. This allows the system to continue to protect
your vehicle using the remaining trigger zones.
You are notified of this active zone immediately after arming the system.
The siren in the vehicle will “ chirp” again and the parking lights will
flash again. The Status LED indicator in the vehicle will blink in a pattern
to indicate the active zone number error which was found (See Table
of Zones on page 36). The 2-way remote control will sound a short
“ error” tone.
Arming without the chirp (Silent Arm):
AUX
Press the button at the bottom of the remote once, and then press
the button. The system will arm without the confirmation chirp. The
parking li ghts will flash once. The 2-way remote will blink the LOCK
indicator to confirm arming. If no arm confirmation is received, the 2-way
remote will give the Out Of Range signal.
➤ While the system is armed
• Fail-Safe Starter Kill
The starter is disabled by the system’s Fail-Safe starter kill.
Alarm Responses
The security system can generate two levels of alarm: Warn Away - Soft
24
© 2008 Directed Electronics. All rights reserved.
To Next Page
Loading...
