Ditch Witch C24x User Manual

Cx Series Operator’s Manual Drive - 45
Shut Down
Reduce Track Wear
Rubber tracks are best suited at soil-based jobsites with minimal rocks and debris. To reduce track wear
drive slowly and make wide turns. Avoid the following:
• spinning tracks under heavy load
• turning on sharp objects such as stones, broken concrete, or debris
• quick turns on asphalt or concrete
• driving over curbs or ledges
• driving with track edges pressed against hard walls or curbs
• operating on corrosive materials such as salt or fertilizer
Shut Down
1. When job is complete, move machine to level ground.
2. Stop machine movement.
3. Lower boom, if space allows.
4. Return all controls to neutral.
5. Set to low throttle.
6. Shut off machine.
7. Insert parking pin (1) in parking position (2).
8. Close fuel shutoff valve, if equipped.
9. If leaving machine unattended, remove key, if
equipped.
IMPORTANT: Stopping position of gear
(3) determines parking position.

Ditch Witch C24x Specifications

General

Engine Make	Kubota
Engine Type	Diesel
Transmission	Hydrostatic
Gross Power	24.8 hp
Max Digging Depth	5 ft
Width	48 in
Horsepower	24.8 hp
Max Trenching Depth	5 ft