Cx Series Operator’s Manual Service - 87
Procedures
Boom Mounting Bolts
Check bolts (shown) every 50 hours. Tighten to
220ft•lb (300N•m) as needed.
Cooler, Hydraulic Fluid
Check before startup. Clean as needed.
1. Check fluid cooler (shown) for dirt and
debris.
2. Clean fins with compressed air or spray wash.
IMPORTANT: C16x, C24x, and C30x only.
NOTICE: Do not use high-pressure air
or water.
t57om015w.eps
To Next Page
Loading...
