Ditch Witch JT920 - Troubleshoot Automation

JT920/JT920L - OPERATION 115
TROUBLESHOOT AUTOMATION
JT920/JT920L - OPERATION 115
TROUBLESHOOT AUTOMATION
TROUBLESHOOT AUTOMATION
Drill Mode
The most common reason for pipeloader automation cycle
interruption in this mode is incorrectly positioned or dirty
photoelectric eyes or reflective tape.
When carriage is moved to back of drill frame, shuttles should
extend and pipe lift arms should raise. If shuttles do not extend,
photoelectric eyes may not be clean or positioned correctly.
• Adjust or clean photoelectric eyes
or tape so that pipe OK light (B) is
on.
• Press pipe shuttle switch to
manually extend shuttles. This will
restart automation cycle.
om0134c.eps
TROUBLESHOOT AUTOMATION
Drill Mode
The most common reason for pipeloader automation cycle
interruption in this mode is incorrectly positioned or dirty
photoelectric eyes or reflective tape.
When carriage is moved to back of drill frame, shuttles should
extend and pipe lift arms should raise. If shuttles do not extend,
photoelectric eyes may not be clean or positioned correctly.
• Adjust or clean photoelectric eyes
or tape so that pipe OK light (B) is
on.
• Press pipe shuttle switch to
manually extend shuttles. This will
restart automation cycle.
om0134c.eps