PROTOCOL AND OPERATIONAL WORK
Displays for series DT-203NN, DT-105NN and DT-110NN
If the device is not found, the message “Error!!! Check the IP Address” will be
showed. This can happen with equipment already installed that works with a dynamically IP
assigned by the PLC, or with offline equipment, which for some reason the IP address has been
changed from default value. If the equipment IP address is unknown, there are some utilities
that find automatically Profinet equipment connected to the network and show their main
parameters. We suggest using the application “Proneta” by Siemens, which is free to download.
This program will perform a network scan and will display the Profinet devices
connected.
Fig. 8 Profinet Displays
To Next Page
Loading...
General