4 5
1. Getting started
Thank you very much for purchasing the
DitoGear™ OmniSlider. We hope that the device
will meet your expectations bringing a great value
to your productions.
Please follow the instructions in this manual
to set up and operate the DitoGear™ OmniSlider.
Please ensure to carefully read the safety instruc-
tions and precautions contained in this manual
prior to use of the device.
Should you need any assistance or support do not
hesitate to contact us at support@ditogear.com.
Product version information
This manual refers to DitoGear™ OmniSlider v2
Controller model, dated 09/2011 and DitoGear™
OmniSlider Controller Firmware build v.11.09.04
Dated 09/2011.
2. Setting up the device
Follow the instructions below to setup the device
for basic operation.
Using the device for the first time
1 Unpack your device and remove protective caps.
2 Stabilize the slider using tripods or optional
DitoGear™ Support Feet Pro.
3 Connect the DitoGear™ OmniSlider
Controller to the motor box located on
the side of the device using the device
using supplied signal cable. Secure the
plugs using the threaded rings on each of
cable’s ends. The plugs and sockets have
an embossed key. Do not force the signal
cable the wrong way.
4 Optionally connect your DSLR Camera
to the DitoGear™ OmniSlider using the
shutter release cable.
5 Place your camera on the trolley using any
accessories of your choice.
6 If operating horizontally, move the trolley
manually to the starting position at the end
of the track, close to the motor box.
7 If operating vertically or diagonally, position
the slider with the motor box at the top end
and place the camera on the lower end.
8 Connect the battery kit or the DC
Adapter to the unit and secure the
power cable to prevent from accidental
disconnection. It may be required
to charge the battery fully prior to first use
of the device.
Unpowering the device
To safely unpower the device please follow
the steps below:
1 If operating in vertical or diagonal mode, park
the trolley at the lower end of the slider.
2 Optionally detach the camera from
the trolley.
3 Disconnect power supply cable.
4 Disconnect other cables.
Caution! Never disconnect the power when the
camera is lifted during operation in diagonal
or vertical mode! Power cuto may cause the trol-
ley to fall and cause damage to your camera!
To Next Page
Loading...