DITTING 1203 - Safety information

9
1203 / 1403 | ENSHOP GRINDER
8
Safety informaon
WARNING!
Danger of electric shock!
Improper use, incorrect electrical installaon or an excessively high
voltage can all lead to electric shock.
– Connect the grinder only if the mains voltage of the socket com-
plies with the informaon indicated on the type plate.
– Connect the grinder only to a socket with good accessibility, so
that you can disconnect it quickly from the power supply in the
event of a fault.
– Do not use the grinder if you noce any visible damage or if the
power cable or plug is faulty.
– If the grinder power cable is damaged, it must be replaced by the
manufacturer or by qualied personnel, in order to avoid hazards.
– Do not operate the grinder without an earth connecon.
– Only connect the grinder to a power supply with a 16 A slow fuse.
Have a 16 A slow fuse installed by a qualied electrician if the
power connecon at the place of installaon of the grinder is not
provided with such protecon.
– Only install the grinder at places where the handling of the
grinder can be supervised by trained personnel.
– Do not immerse the grinder or the power cable or power plug in
water or any other liquids.
– Do not clean the grinder with a water jet.
– Never touch the power plug with wet hands.
– Never unplug the power plug from the wall socket by pulling on
the power cable; always grip the plug itself.
– Never use the power cable as a handle to carry the grinder.
– Keep the grinder and power cable/power plug away from open
ames and hot surfaces.
– Posion the power cable in such a way that it does not become a
trip hazard.
– Do not bend the power cable and do not place it over sharp
edges.