Page 9
Resetting the cleaning counter: Enter the menu by pushing and hold-
ing both buttons for appr. 3 seconds. Scroll through the menu with
the single pre-selection button (pos. 8) until the display reads GRINDZ.
From this point exit the menu by pressing and holding both buttons for
appr. 3 seconds. The counter will be set back to Zero.
6.4.4 Disc counter
Furthermore the grinder is equipped with a disc counter that will show
DISC in the display after the defined amount of 100,000 single shots.
The grinder can still be used but the discs should be
changed regularly (see chapter 9) in order to assure
best possible grinding quality and speed.
• Resetting the disc counter: Enter the menu by pushing and hold-
ing both buttons for appr. 3 seconds. Scroll through the menu with
the single pre-selection button (pos. 8) until the display reads
DISC. From this point exit the menu by pressing and holding both
buttons for appr. 3 seconds.
• For entering the PIN use the left potentiometer to change the dig-
its and press the single button to jump to the next number. The
PIN is 0408.
• The counter will be set back to Zero and the display will read PIN
OK.
A disc change should always be carried out by a
trained service technician in order to assure correct
procedure and recalibration after the change.
NEW
To Next Page
Loading...
