Page 10
Defect
The grinder hums but
does not grind.
The grinder does not
grind, the display is
lit, single cup is pre-
selected
Defect
The grinder does not
start, the operating
mode display is not
lit.
In the case of other malfunctions or continued faults, please contact your
dealer or your authorised customer service centre.
7. Operating faults
Cause
The spout is
clogged.
Grinding is set too
fine.
A foreign object is in
the grinding mecha-
nism.
The grinding time is
set to O.
Cause
The main plug is not
inserted.
The overload circuit
breaker has been
tripped.
The pre-fuse has
tripped.
Remedy
Set grinding fineness to
“coarse” and trigger the
grinding process. The grinder
will then grind itself free. Af-
terwards, return the setting to
the desired grinding fineness.
Turn the grinding fine-
ness setting to the right, to
“coarse”, and trigger the
grinding process. The grinder
will then grind itself free. Af-
terwards, return the setting to
the desired grinding fineness.
Clean the grinding mecha-
nism as described and re-
move the foreign object. Ob-
serve the safety instructions!
Reset the grinding time.
Remedy
Insert the main plug into the
socket.
Check to determine whether
the trip button of the circuit
breaker has jumped out.
Press the trip button in again
if appropriate. If the circuit
breaker trips repeatedly,
contact your authorised
customer service centre or
dealer.
Check the pre-fuse. Restore
the pre-fuse to its initial state
or replace it. Determine
whether other devices are
connected to this fuse.
To Next Page
Loading...
