49
Chapter 2: Camera Configuration
Outside for Zone Counting: Objects entering from outside the zone area
to the inside will be counted as Outside. Objects leaving from inside the
zone area to the outside will not be counted as Inside or Outside.
Count Reset
Resets all the counting results of Line Counting or Zone Counting to zero.
Setup Detection Area
Enable
Enables or disables the detection area for monitoring objects. When enabled,
the minimum and maximum width and height of the detection area can be
configured through the slider bars.
Save
Save button to apply the configurations, click on this button once all the
settings are confirmed for the new changes to take effect.
Object Detection Cont.
To Next Page
Loading...