Page 30
DROP SENSOR (PASSWORD REQUIRED)
Allows Enabling or Disabling of drop sensor Credit Guard function. When Enabled the customer will retain credit for
amount deposited if a product does not pass through the sensor beam in the recovery unit. This state will allow 3
attempts to vend a product before credit is lost. Both states will prevent a vend if a product is in the recovery unit.
Press the number "8" on the keypad and "ENABLE DROP SENSOR" will scroll across the display followed by the
current state; N - DISABLED, Y - ENABLED. To change, press the "*" key and the display will prompt for the
password. After the password has been entered, pressing the "*" key will switch the state. Press the "CLR" key to
return to "SETUP MODE".
SET COOL TIME
Allows the service technician to vary the time duration of the cool down period from 0 to 255 minutes. If no time is
entered here, and the SET COOL DOWN feature is started, the time duration of the cool down period will be 240
minutes (4 hours). To set the cool down time press the letter "D" on the keypad and the display will read "SET
COOL TIME". Press the "*" key and the display will read "COOL T". Use the keypad to enter the duration of the
cool down period that you wish to use. Press the "*" key to enter the cool down time displayed. Press the "CLR"
key to return to "SETUP MODE".
SET PASSWORD (PASSWORD REQUIRED)
Allows the service technician to enter a personalized password.
IF YOU DECIDE TO CHANGE FROM THE DEFAULT PASSWORD, PLEASE ENTER THE NEW PASSWORD
SLOWLY AND CAREFULLY!!!
Press the number "0" on the keypad and "ENTER PASSWORD" will scroll across the display. Press the "*" key and
the display will read "PW". Enter the password, the display will read "OK" momentarily then " NEW PW" will be
displayed. Enter the new password. After the fourth character of the new PW is entered the display will scroll
"ENTER PASSWORD". Press the "CLR" key and the display returns to "SETUP MODE".
To Next Page
Loading...
