Page 32
NUMBER SOLD
Shows total number of items sold since last CLEAR TOTALS or MASTER RESET.
Press the number "1" on the keypad and the display will read "NUMBER SOLD ###".
Press the "CLR" key to return to "SERVICE MODE".
ENABLE ITEM
Allows an individual selection, a complete tray, or the entire machine to be enabled or disabled.
Press the number "2" on the keypad, display will read "ENABLE ITEM". Press the "*" key, and the display will read
"ITEM". There are now three choices:
1. Pressing the "*" key will toggle between enable and disable for the entire machine. The display
will show the current state.
2. Pressing a tray selection followed by "*" will show the current state of that tray. (For example,
pressing "A*" will show the current state for the A tray. Pressing "A*" again will toggle the
state.)
3. Pressing an item selection will show the current state of that item. (For example, pressing "A1"
will show the current state of that item. Pressing "A1" again will toggle the state.)
Press the "CLR" key to return to "SERVICE MODE".
SET PRICE
Allows setting of regular prices for an individual item, a complete tray, or the entire machine.
Press the number "7" on the keypad, the display will scroll "SET REGULAR PRICES" once, then "$00.00" will be
displayed. Prices are entered using the numbers on the keypad and will shift in from the right as numbers are
pressed. Price setting is covered in detail in the INITIAL PROGRAMMING section of this manual. See pages 36,
37, and 38. Press the "CLR" key to return to "SERVICE MODE".
SET HAPPY
Allows setting of Happy Hour prices for an individual item, a complete tray, or the entire machine.
Press the number "8" on the keypad, the display will scroll "SET HAPPY HOUR PRICES" once then "$00.00" will be
displayed. Happy Hour prices are entered in the same way as regular prices. Refer to price setting in the INITIAL
PROGRAMMING section of this manual. See pages 40 and 41. Press the "CLR" key to return to "SERVICE
MODE".
TEST VEND
Allows the service technician to test vend any item.
Press the number "9" on the keypad and the display will read "ITEM". Select the item/column to be tested by
pressing the corresponding keys on the keypad (i.e. A6), and the corresponding solenoid will cycle. Press the
"CLR" key to return to "SERVICE MODE".
CLEAR ERRORS
Allows the service technician to clear any recorded errors. Press the number "0" on the keypad and the display will
read "CLEAR ERRORS * = Y". Press the "*" key. The errors are cleared and the display returns to "SERVICE
MODE".
To Next Page
Loading...
