Page 34
SELF TEST
Allows the service technician to run a quick diagnostics of all systems. Press the letter "C" on the keypad and the
display will read "SELF TEST * = Y". Press the "*" key, the test will be run and the display will read "ERRS = ##".
Normal error indications are based on the machine's configuration. The service technician should list errors after
Self Test. Press the "CLR" key to return to "TEST MODE".
DISPLAY TEST
Allows the service technician to check all segments of the LED display unit. PRESS AND HOLD the letter "D" on
the keypad and the display will alternate between all *'s and all 0's with decimal points. Releasing the letter "D" on
the keypad will return to "TEST MODE".
KEYPAD TEST
Allows the service technician to test any or all keypad keys.
Press the letter "E" on the keypad, the display will go blank, then each keypad entry will shift in the display from the
right until the "CLR" key is pressed. This will return to "TEST MODE".
AUTO SEQUENCE
Allows the service technician to put the machine into automatic vend. An item will be vended every second, starting
from A1 and running through the ninth selection on the bottom tray of the machine, then repeating until the service
technician stops it.
Press the letter "F" on the keypad and the display will read "OK? * = Y". Press the "*" key, automatic vend will start,
display will show channel/solenoid currently being tested. Press the "*" key to pause and restart the sequence,
press the "CLR" key to stop and return to "TEST MODE".
CAUTION: It is strongly recommended this feature only be used to check channels/solenoids on empty
machines.
DOOR OPENINGS
Shows number of times the service door has been opened since last CLEAR TOTALS or MASTER RESET.
Press the number "5" on the keypad and "DOOR OPEN #" will scroll across the display. Use the "*" key, and the
"A" key, to view the day, date, and time of the last 5 openings.
POWER OUTAGES
Shows number of times the machine has lost power since last CLEAR TOTALS or MASTER RESET. (This is a
power outage for any reason including the machine being unplugged and the machine's master power switch being
turned off).
Press the number "6" on the keypad, "PWR OUT #" will scroll across the display. Use the "*" key, and the "A" key,
to view the day, date, and time of the last 5 power outages. Press the "CLR" key to return to "TEST MODE".
CLEAR ERRORS
Allows the service technician to clear any recorded errors.
Press the number "0" on the keypad, the display will read "CLEAR ERRORS * = Y", press the "*" key, the errors are
cleared and the display returns to "TEST MODE".
To Next Page
Loading...
