Pre-flight Checklist
1. Make sure that the remote controller and aircraft batteries are fully charged. (It is
recommended to fully charge the battery and then fly the drone.)
2. Make sure that the propellers are mounted properly. Check whether the propellers are broken
or bent, and whether all the propellers are unfolded.
3. Connect your mobile device to the remote controller. Power on the remote controller first and
then power on the aircraft. Unfold the remote controller antennas and check whether the
remote controller is linked with the aircraft. Check whether there are any warnings shown under
Aircraft Status in the app, such as compass, IMU, or vision sensors error). Check whether the
image transmission signal is strong at the takeoff point. When "Ready to Go" is shown on the app
screen and a "HomePoint updated" prompt is displayed, enjoy your flight.
4. It is recommended to set "No RC Signal Action" to "RTH" under the remote controller Settings
in the app. (The aircraft will automatically return to the Home Point when the remote controller
signal is lost.)
5. It is recommended to set the RTH Altitude higher than the height of obstacles in the
surrounding environment to avoid collisions during RTH.
Precautions During Flight
1. Make sure that the antenna of the remote controller is aligned with the flight direction of the
aircraft during flight, and pay attention to the image transmission signal strength. If a warning
stating that the signal is weak or lost is displayed in the app, please try adjusting the antenna to
To Next Page
Loading...
