dji FLYCART 30

6
©
2024 DJI All Rights Reserved.
DJI FlyCart 30 Winch System User Guide
Mounting a Large Cargo Volume
When the cargo is too large to place within the landing gear, or the density of the cargo is
so great (e.g. a steel block) that it may damage the aircraft during delivery, an extension
cable should be used. The two ends of the extension cable should connect to the winch
system and cargo, respectively.
• Extension cables are provided in the winch system package.
• If users are planning to use a steel extension cable, it is recommended that a
galvanizedsteelwireropewitha≥3mmdiameterisused.
• Both a rotating ring and carabiner need to be used with the extension cable. The
carabiner and extension cable need to be attached to the different sides of the
rotating ring.
• The length of the extension cable should be less than 0.4 m or greater than 5 m.
Otherwise, the cargo will swing back and forth, consequently affecting flight safety.
• Check to make sure the extension cable is in good condition before each flight.
a. Check to make sure the extension cable is smooth, and be sure to undo any
knots if any are found.
b. Check if the carabiner can be closed normally. If not, replace it before using.
c. Check to make sure the extension cable is not broken. If it is, replace it before
using.
d. Check if the extension cable is attached to the correct side of the rotating ring.
Weight Sensor Calibration
When the aircraft is hovering without payload but the measured weight does not equal 0,
weight sensor calibration is needed.
Calibration Procedure
1. Take off and hover at 5 m with no payload for 10 seconds.
2. In DJI Pilot 2 Camera View, tap
>
>
Tethered Descent Calibration > Weight Sensor
Calibration.
• It is recommended to calibrate the weight sensor at least once a month to ensure
accuracy.