There are two choices Follow and First Person View (FPV).
Follow: In this mode, the camera will remain stable and maintain the horizon
FPV: This orients the gimbal with the movement of the drone. So when you change the
orientation of the drone, the camera view will move with it.
Centring Camera: If you tap this then the camera will move into center place horizontally
or straight down.
Adjust Gimbal Roll: You can use this to adjust the tilt of the gimbal if it is misaligned.
You can do this when flying rather than having to bring your drone back to fix it.
Gimbal Auto Calibration: The drone will automatically try to center the gimbal, this
must be done when the drone is on a level surface.
Advanced Settings:
Here you can set gimbal functions.
Gimbal Pitch Speed: This controls the speed at which the gimbal tilts. A higher value
means a faster-moving gimbal and lower value means a slower gimbal.
Enable Upwards Gimbal Tilt Limit to 30 Degree: Turning this off will allow the camera
to tilt up beyond 30, but you’ll be able to see the propellers in any shots you take. Unless
you are flying backward.
To Next Page
Loading...
