File Index Mode: This controls the file numbers assigned to videos and photo you make
with your drone. If you set it to continuous, then the number will just keep on going up
with every picture or video you take. If it is reset, then the number will start again at 001.
Peak Focus Threshold: This adds red lines around edges to indicate focus. You can
switch between off/low/normal/high these setting control when the effect activates.
Format SD Card: This wipes your SD card’s information.
Reset Camera Settings: This will reset camera’s settings to default if activated.
Video Settings:
Here you can configure how drone takes videos.
Video Size:
Here you can choose from a range of resolutions and frames per second. The options
you’ll see here will depend on what drone you’re flying or which camera you have attached
to your Inspire 2.
To Next Page
Loading...
Need help?
General
