©
2023 DJI All Rights Reserved.
27
DJI RC Motion 2
To ensure flight safety when controlling the aircraft with the motion controller,
press the lock button once to make the aircraft brake and hover before operating
the goggles. Failure to do so is a safety risk and may lead to the aircraft losing
control.
Mode Button
The motion controller has two modes: Normal mode and Sport mode. Normal mode is
selected by default. Press the mode button to switch between Normal and Sport mode.
Press and hold to initiate RTH. Press again to cancel RTH.
Lock Button
Use the lock button to control the takeo, landing, and brake of the aircraft:
Takeo: press twice to start the aircraft motors, then press and hold to make the aircraft
take o. The aircraft will ascend to approximately 1.2 m and hover.
Landing: press and hold the lock button while the aircraft is hovering to land and stop the
motors automatically.
Brake: during ight, press once to brake the aircraft and make it hover in place with the
attitude locked. Press again to unlock the attitude and resume the ight control.
When the aircraft is performing RTH or auto landing, press the button once to cancel RTH
or landing.
Critical Low Battery landing cannot be canceled.
Stopping Aircraft Motors Mid-flight: if an emergency occurs (such as a collision or the
aircraft is out of control) during ight, pressing the lock button four times can stop the air-
craft motors immediately.
Stopping motors mid-ight will cause the aircraft to crash. Operate with caution.
Controlling the Aircraft
Lock Button
Joystick
Mode Button
Accelerator
To Next Page
Loading...
