©
2023 DJI All Rights Reserved.
9
Getting Started
This chapter helps users with rst time use.
Preparing the Goggles
Installing the Corrective Lenses
The goggles are equipped with a pair of eyeglass frames and come with 10 pairs of vision
corrective lenses (from -8.0 diopter to +2.0 diopter, without astigmatism correction) and
one pair of plain lenses (0 diopter). Users can install suitable lenses according to their ac-
tual eyesight.
Even if vision correction is not necessary, it is strongly recommended to install
the plain lenses to protect the goggles screen glasses from being scratched.
If astigmatism correction is needed or the provided lenses are not suitable, us-
ers can purchase additional lenses. When purchasing lenses, take the eyeglass
frames (a pair) and a pair of lenses to a professional optician to ensure that the
shape, size, astigmatism axis, and edge thickness (< 2.8 mm) of the lenses meet
the installation requirements of the eyeglass frames.
1. Detach the eyeglass frames from the goggles (no need to rotate the frames). Turn over
the frames and identify the shortest line mark (a), the longest line mark (b), and the
side line mark (c), as shown in the diagram below.
2. Take out the suitable lenses from the package. The diopter of the lenses is printed on
the inside of the lens box lid and also marked on the edge of each lens. Identify the
shortest cut edge (a), the longest cut edge (b), and the side cut edge (c), as shown in
the diagram below.
a
a
-7D
-8D -5D-6D -3D-4D
-1D
-2D
+1D
0D
+2D
To Next Page
Loading...
