dji GOGGLES INTEGRA MOTION COMBO - Controlling the Camera

DJI Goggles Integra Motion Combo User Manual
©
2023 DJI All Rights Reserved.
29
The ying speed controlled by the joystick and the accelerator can be congured
as below:
1. Press down the 5D button to open the menu from the FPV view
2. Select
Settings > Control > Motion Controller > Gain Tuning
, then set the
maximum speed in each direction.
Controlling the Camera
Shutter/Record Button
FN Dial
FN Dial
Adjusting the camera parameters: press the dial to open the camera settings panel from
the FPV view of the goggles. Scroll the dial to navigate the settings menu or adjust the pa-
rameter value, then press the dial to conrm the selection. Press and hold the dial to exit
the current menu.
Controlling the camera tilt: before takeo or during RTH and landing, press and hold the
dial from the FPV view and then scroll up or down to tilt the camera. Release the dial to
stop the camera tilt.
Shutter/Record Button
Press and hold to switch between the photo and video modes. Press once to take a photo
or to start or stop recording.