! Ensure that you have obtained the landowners permissions (preferably in writing)
• Complete the pre-site survey using the i fly imaging assessment form
• Complete any actions required to mitigate risk
• Inform client if operation is possible
• Charge sufficient batteries and check condition
• Check firmware is all up to date. Update if required (By Nicholas Perry)
• Check airframe, gimble, camera & remote for damage. Check all functioning
correctly
• Record any defects on battery & service logs
• Check destination, travel time & route
• Compile paperwork ready for operation
• Pre-site survey
• Plan for shoot
• Checklists & crew responsibilities
• Unexpected eventualities/ emergency procedures
! Complete the site assessment using the I fly imaging on-site assessment form
! Complete any actions required to mitigate risk
! Secure the site from third parties
! Secure take-off and landing zones if required
! Review technical log for defects
! Check any maintenance action/defects has been completed/cleared
! Assemble airframe (propellers, motors, gimbal and sensors)
! Check condition of equipment
! Position equipment as required
! Check condition and charge sufficient for flight
! Connect to aircraft electrical system
! Propellers: check position, mounting and condition
! Battery: check mounting
! Airframe: check general condition, connections and fittings
! Payload mounting: secure
! Review emergency landing and holding areas
! Check that signal strength is ‘good’ and free of interference
To Next Page
Loading...
