dji MATRICE 200

©
2017 DJI All Rights Reserved.
43
MATRICE 200 User Manual
In Dual Controller Mode, when the Master remote controller is primary, it can control
gimbal pitch and pan. When the Slave remote controller is primary, it can control gimbal
pitch, pan, and roll.
Dual Remote Controller mode is not available in Russia and Israel.
Setting Up Dual Remote Controller Mode
Dual Remote Controller mode is disabled by default. Users must enable this feature on the Master
remote controller via DJI GO 4. Follow the steps below to setup:
Master Remote Controller:
1. Connect the remote controller to your mobile device and launch DJI GO 4.
2. Go to the Camera View and tap
to enter the remote controller settings window.
3. Select Master and set the remote controller as the Master remote controller.
4. Enter the connection password for the Slave remote controller.
Master
Master ID: 28172d Slave ID: 14f93f
Connection Status:ON Authorization Code:
Set Remote Controller Status
Master and Slave
Remote Controller Calibration
666666
Remote Controller Settings
Slave
OFF
When in Slave, the remote controller cannot link to the aircraft nor control aircraft orientation.
Select Master in DJI GO 4 if you wish to connect and control the aircraft with the remote
controller.
“Slave” Remote Controller:
1. Select Slave to set the remote controller to Slave.
Search Master
Remote Controller Settings
Master and Slave
Set Remote Controller Status
Master
Slave
OFF
Master ID: 28172d Slave ID: 14f93f
Connection Status:OFF