dji MATRICE 200

70
©
2017 DJI All Rights Reserved.
MATRICE 200 User Manual
The rmware update will take around 15 minutes. It is normal that the gimbal will go limp, the
aircraft status indicator blinks abnormally when the aircraft reboots. Wait patiently until the
update is complete.
During an update, the aircraft will sound a quick single beep continuously. The warning
sound will then alternate between a longer beep and a quick double beep once the
update is complete. Restart the aircraft after the rmware update is complete.
If the warning sound turns into a long beep, retry the update.
The battery level should be above 30% for the rmware update process.
When using DJI GO 4 to update, you may disconnect the aircraft and the mobile device
once the update is more than 30% completed. No Internet connection is required.
Upgrading the Remote Controller Firmware
Method 1: Using the DJI GO 4 App
Power on the remote controller and connect it with the DJI GO 4 app. A prompt will appear if a
new rmware upgrade is available. To start upgrading, connect a mobile device to the Internet and
follow the on-screen instructions.
Ensure the battery level is adequate for the remote controller.
Do not disconnect the aircraft from the computer during a rmware upgrade.
After-Sales Information
Visit the following pages to learn more about our After-sales Service Policy and warranty information:
1. After-sales Policy: http://www.dji.com/service
2. Refund Policy: http://www.dji.com/service/refund-return
3. Paid Repair Service: http://www.dji.com/service/repair-service
4. Warranty Service: http://www.dji.com/service/warranty-service