dji MATRICE 300 RTK - Page 107

©
2020 DJI All Rights Reserved.
107
MATRICE 300 RTK User Manual
Aircraft Firmware Update
1. Power on the aircraft. Connect the aircraft to a PC with a Type-C USB cable.
2. Run the DJI Assistant 2. Click the corresponding device name and then the rmware update tag.
3. Select the rmware version required. Make sure to connect to the Internet when downloading the rmware.
4. Restart the device after the rmware update is complete.
CSM Radar rmware updates are included with aircraft rmware updates.
H20 series Firmware Update
1. Install the H20 series payload onto the aircraft. Power on the aircraft. Connect the aircraft to a PC
with a Type-C USB cable.
2. Run the DJI Assistant 2. Click the corresponding device name and then the H20 series rmware
update tag.
3. Select the rmware version required. Make sure to connect to the Internet when downloading the
rmware.
4. Restart the device after the rmware update is complete.
The battery rmware is included in the aircraft rmware. Be sure to update all the batteries' rmware.
The aircraft battery level should be above 25% and the remote controller battery level should
be above 50% for the rmware update process.
Make sure all the devices are connected normally during update.
It is normal that the gimbal will go limp, the aircraft status indicator blinks abnormally when
the aircraft reboots. Wait patiently until the update is complete.
Make sure to keep the aircraft away from people and animals during rmware update, system
calibration and parameter setting.
Be sure to update the rmware to the latest version to ensure ight safety.
After the firmware update is completed, the remote controller and the aircraft may be
disconnected. If necessary, re-link them.