dji MATRICE 300 RTK - FPV Camera View

©
2020 DJI All Rights Reserved.
67
MATRICE 300 RTK User Manual
FPV Camera View
Using FPV Camera View
After tapping Enter Camera View on the homepage of DJI Pilot 2 and nishing the preight check, you
will be directed to FPV camera view by default.
1. Top Bar: displays the aircraft status, ight mode, signal quality, etc. Refer to the Top Bar section for
more details.
2. Beacons Switch: Tap to turn the beacons on or o.
3. Discreet Mode Switch: Tap to turn off the aircraft rear indicators and front indicators, beacons,
auxiliary light, and battery indicators. After enabling Discreet Mode, the auxiliary light will not turn on
during landing, which may present certain risks. Use Discreet Mode with caution.
4. Flight Route: Tap to enter the ight route library. Users can create and view all ight tasks and more.
5. Map View: Tap to switch to map view. The map view supports zooming in and out.
6. Gimbal Camera View: Tap to switch to gimbal camera view. The gimbal camera view supports
zooming in and out.
7. AR Projection: projects information such as PinPoints, waypoints, and the Home Point in FPV
camera view and gimbal camera view to improve ight perception. Refer to the AR Projection section
for more details.
8. Primary Flight Display (PFD): shows parameters such as attitude, speed, altitude, and wind speed
during a ight. Refer to the Primary Flight Display (PFD) section for more details.
1
2
3
4
5
6
7
8