dji MATRICE 300 RTK - Page 33

©
2020 DJI All Rights Reserved.
33
MATRICE 300 RTK User Manual
Battery Station Firmware Update
Use the DJI Pilot 2 App to update rmware of the Battery Station as well as up to 8 TB60 ight batteries
at the same time.
1. Insert the batteries into the Battery Ports and turn on the Battery Station.
2. Connect the Battery Station to the remote controller using a USB-C cable.
3. Turn on the remote controller and make sure it is connected to the Internet.
4. Run the DJI Pilot 2 app. If it shows that there is a rmware update for the Battery Station, then tap
into the HMS page.
5. Tap to enter the rmware update page.
6. Tap the update all button and wait for about 10 minutes to complete the rmware upgrade.
During rmware update, do not insert or remove the battery to avoid battery update failure.
During rmware update, do not unplug the USB-C cable to avoid battery update failure.
During rmware update, do not use the battery station to charge the battery.