42
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
External Battery
1. Connect the Battery Station to a power outlet (100-120 Vac, 50-60 Hz / 220-240 Vac, 50-60 Hz).
2. Press the Power Button once to turn on the Battery Station.
3. Insert the batteries into the Battery Ports to start charging. The Battery Station will charge the battery
with the highest remaining battery power rst.
Power Outlet
2
1
3
Mounting the WB37 Intelligent Battery
1
Press and hold the battery release button.
2
Insert the Intelligent Battery into the battery compartment. Make sure the bottom of the battery is
aligned to the marking line in the compartment.
3
Push the battery to the bottom.
To remove the Intelligent Battery, press and hold the battery release button, then push the
battery upward.
Mounting the 4G Dongle and SIM Card
Only use a DJI-approved dongle.
The dongle and SIM card enable the Smart Controller to access 4G network. Make sure to
deploy these correctly, otherwise, network access will not be available.
The dongle and SIM card are excluded.
To Next Page
Loading...
