To Next Page

To Previous Page

Getting Started

Intelligent Battery

The 1225 mAh Intelligent Battery can power the Osmo+ for about 114 minutes.

Charging the Battery

Connect the battery charger to a power outlet using the provided cable.

Place the battery into the battery charger. It will take approximately 110 minutes for the

battery to be fully charged, refer to the "Status LED Indicator Descriptions" section below for

more information about the Status LED Indicator's blinking patterns.

Status LED Indicator Descriptions

—

Solid Yellow No battery detected

......

Blinking Green

(within a

certain time)

Blinks once < 25%

Blinks twice 25% to 49%

Blinks three times 50% to 74%

Blinks four times 75% to 99%

—

Solid Green Fully charged

—

Solid Red Charger error, check the connection to the Battery Charger

Intelligent Battery Functions

Battery Balancing Balances the voltage of each cell during charging.

Overcurrent Protection Stops charging if the charging current is too large.

Overcharge Protection Stops charging if its voltage is too high.

Over-discharge Protection Stops discharging if its voltage is too low.

Short Circuit Protection Cuts the power supply if a short circuit is detected.

Temperature Control

Stops charging if the core temperature falls below 41°F (5°C)

or exceeds 104°F (40°C).

Battery Level Display The battery level is displayed in the DJI GO app.

Other manuals for dji OSMO+

Questions and Answers:

Need help?

Do you have a question about the dji OSMO+ and is the answer not in the manual?

General