To Next Page

To Previous Page

FAQ

Phantom 3 Advanced

User Manual

Various factors contribute to the aircraft initialization error, try resolve the issue by following the suggestions

listed below:

• Sensor performance degraded. This may be due to the excessive bias detected from the IMU or the

compass reading is interfered. Try restarting and calibrating the IMU and compass to resolve this issue.

• Sensor is defective. If the sensors remains unchanged at all time and the problem persist even when the

aircraft is restarted, it indicates the sensor is not working normally. Users should return the aircraft to DJI

for repairing.

• Minor vibration is detected during aircraft initialization. Put the aircraft on the at surface, power on the

aircraft and ensure the aircraft is stationed for more than 5 seconds to resolve the issue.

• Serious vibration is detected during aircraft initialization. This instance generally occurs when the aircraft

is being initialization on the violent moving surface, for instance, ships that are on the rough sea. Do not

attempt to power on the aircraft in this scenario.

Other manuals for dji PHANTOM 3

Questions and Answers:

Need help?

Do you have a question about the dji PHANTOM 3 and is the answer not in the manual?

General

Max Flight Time	23 minutes
Battery Capacity	4480 mAh
Weight	1280 g (Including battery and propellers)
Max Ascent Speed	5 m/s
Max Descent Speed	3 m/s
Max Service Ceiling Above Sea Level	6000 m
GPS Mode	GPS/GLONASS
Battery Voltage	15.2 V
Battery Type	LiPo 4S
Max Charging Power	100 W
Lens FOV	94°
Aperture	f/2.8
Shutter Speed	8s -1/8000s
Max Image Resolution	4000 x 3000
Max Bitrate	40 Mbps
Max Speed	16 m/s (ATTI mode, no wind)
Video Resolution	2.7K: 2704x1520p 24/25/30 (29.97); FHD: 1920x1080p 24/25/30/48/50/60
Operating Temperature	0°C to 40°C
Transmitter Power (EIRP)	20 dBm (FCC), 14 dBm (CE)
Video Recording Modes	2.7K, FHD
Camera Sensor	1/2.3" CMOS
ISO Range	100-3200 (video), 100-1600 (photo)
Photo Formats	JPEG, DNG
Video Formats	MP4/MOV (H.264)
Remote Controller Operating Frequency	2.4 GHz
Mobile Device Holder	For mobile phones or tablets
Hover Accuracy Range	Vertical: +/- 0.5 m; Horizontal: +/- 1.5 m