To Next Page

To Previous Page

Preparing the Remote Controller

Charging the Battery

The built-in battery is placed in hibernation mode before delivery. It must be charged before using for the

rst time.

It takes approximately two hours to fully charge the remote controller using a recommended USB

charger rated 12V and one and a half hours using a recommended USB charger rated 15V.

Power Outlet

100~240 V

USB Charger

USB-C Cable

It is recommended to use an FCC/CE certied USB charger rated 12V or 15V.

Recharge the battery at least every three months to prevent over discharging. The battery depletes

when stored for an extended period.

Mounting

1. Remove the control sticks from the storage slots on the remote controller and screw them into place.

2. Unfold the antennas.

Remove the control

sticks from the

storage slots

Attach the control

sticks and twist to

secure

Unfold the antennas

Make sure the control sticks are rmly mounted.

Activating the Remote Controller

The remote controller needs to be activated before using for the rst time. Make sure the

remote controller can connect to the internet during activation. Follow the steps below to

activate the remote controller.

1. Power on the remote controller. Select the language and tap “Next”. Carefully read the terms of use

and privacy policy and tap “Agree”. After conrming, set the country/region.

2. Connect the remote controller to the internet via Wi-Fi. After connecting, tap “Next” to continue and

select the time zone, date, and time.

Internet

Other manuals for dji RC Pro

Questions and Answers:

Need help?

Do you have a question about the dji RC Pro and is the answer not in the manual?

General