8
©
2022 DJI All Rights Reserved.
Remote Controller Operations
Checking the Battery Level
Press the power button once to check the current battery level.
Powering On/O
Press and then press again and hold to power the remote controller on or o.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a combo. Otherwise,
follow the steps below to link the remote controller and the aircraft after activation.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. In camera view, tap and select Control and then Pair to Aircraft (Link).
4. Press and hold the power button on the aircraft for more than four seconds. The aircraft will beep
once when it is ready to link. After the linking is successful, the aircraft will beep twice and the battery
level LEDs of the remote controller will appear on and solid.
Make sure the remote controller is within 0.5 m of the aircraft during the linking.
The remote controller will automatically unlink from an aircraft if a new remote controller is linked to
the same aircraft.
Turn o Bluetooth and Wi-Fi of the remote controller for optimal video transmission.
Fully charge the remote controller before each ight. The remote controller sounds an alert when the
battery level is low.
If the remote controller is powered on and not in use for ve minutes, an alert will sound. After six
minutes, the remote controller automatically powers o. Move the control sticks or press any button
to cancel the alert.
Fully charge the battery at least once every three months to maintain the battery’s health.
HighBatteryLow
To Next Page
Loading...
Need help?
General
Weight and Dimensions
