dji SPARK Quick Start Guide

8
©
2017 DJI All Rights Reserved.
 $IFDLDBNFSBTFUUJOHTCFGPSFVTFUPNBLFTVSFZPVDBOBEKVTUUIFNUPmUZPVS
needs.
2. Test the camera by shooting a few test images and check that it is operating
correctly before shooting important pictures or videos.
3. DO NOT remove the Micro SD card from the aircraft when it is powered on.
4. Photos or videos cannot be transmitted or copied from the camera if the
Intelligent Flight Battery is powered off.
5. Be sure to power off the Intelligent Flight Battery correctly, otherwise your camera
parameters will NOT be saved and any recorded videos may be damaged.
NOTE: Regardless of the reason, DJI will not be responsible for any failure of
an image or video to be recorded or having been recorded in a way that is not
machine readable.
*LPEDO
1. Precision elements in the gimbal may be damaged in a collision or impact, which
may cause the gimbal to function abnormally.
 %0/05BQQMZFYUFSOBMGPSDFUPUIFHJNCBMBGUFSUIFHJNCBMJTQPXFSFEPO
3. DO NOT add any payloads to the gimbal, as this may cause the gimbal to
function abnormally or even lead to motor damage.
&RPSDVV
To avoid possible serious injury and property damage, observe the following rule:
 -BOEJNNFEJBUFMZXIFOPCWJPVTESJGUJOHPDDVSTJOnJHIUJFUIFBJSDSBGUEPFT
/05nZJOTUSBJHIUMJOFT
Only calibrate the compass when the DJI GO 4 app or the status indicator prompt you
to do so. Observe the following rules when calibrating your compass:
1. DO NOT calibrate your compass where there is magnetic interference, such as
interference by magnetite, parking structures, or steel reinforcements underground.
2. DO NOT carry ferromagnetic materials with you during calibration such as
cellular phones.
3. The DJI GO 4 app will prompt you to resolve the compass issue if the compass is
affected by strong interference after calibration is complete. Follow the prompted
instructions to resolve the compass issue.
3URSXOVLRQ6\VWHPV
7RDYRLGVHULRXVLQMXU\WR\RXUVHOIRURWKHUVZKLFKPD\EHFDXVHGE\WKH
URWDWLQJSURSHOOHUVDQGPRWRUVREVHUYHWKHIROORZLQJUXOHV

dji SPARK Specifications

Operating Environment

max speed	31 mph (50 kph)
operating temperature	32° to 104° F (0° to 40° C)
charging temperature	41° to 104° F (5° to 40° C)

Camera

sensor	1/2.3” CMOS
effective pixels	12 Megapixels
video recording modes	FHD: 1920×1080 30p

Power

charger input	100-240 V, 50/60 Hz, 0.5 A
charger output	5 V 3 A / 9 V 2A / 12 V 1.5 A
battery capacity	1480 mAh

Remote Control

operating frequency	2.4G / 5.8G
max transmission distance (Wi-Fi)	100 m (Distance), 50 m (Height)
max transmission distance (Remote Controller)	2000 m

Weight and Dimensions

weight	300 g
dimensions	143×143×55 mm