1.5 Board and Relay Identification
When using two or more Tracker boards connected to a single access system, the board jumpers on
each tracker board must be set so that the access system can identify each tracker board. There are
six sets of jumper pins on the tracker board labeled J1 through J6. Shorting bars placed on the
jumper pins create a unique address for each tracker board to identify itself to the access control
system.
1.5.1 Board Identification
J1
J3
J6
J4
J2
J5
BOARD 1 BOARD 3 BOARD 4 BOARD 5 BOARD 6 BOARD 7 BOARD 8
BOARD 9 BOARD 10 BOARD 11 BOARD 12 BOARD 13 BOARD 15 BOARD 16
BOARD 2
BOARD 14
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev.Dwg. No.
Board Identification
Jumper Pin Setup
4/02 M2351-065-2
A
2351-065-G-12-07 Page 15
To Next Page
Loading...