DKS 6002 User Manual (English)

Other manuals for DKS 6002

Owner's Manual41 pages

Installation Guide28 pages

Questions and Answers:

W
Wayne FoleyAug 14, 2025
What to do if external reversing devices cannot be made operable on my DKS Controller?
- K
  Kiara SmithAug 14, 2025
  If external reversing devices cannot be made operable, immediately remove the DKS Controller from service. Continuing to use the controller with a malfunctioning reversing system creates a hazard that can result in serious injury or death if someone becomes entrapped in the gate. Do not place this operator in service until the malfunction can be identified and corrected.
M
Michael DavisAug 18, 2025
What to do if my DKS 6002 opens but won't close?
- J
  John BoydAug 18, 2025
  If your DKS Gate Opener opens but won't close, check the following: * Input LEDs: Any that are ON indicate a problem with a keying device. * Secondary safety devices: Any that are activated will hold the gate open, indicating a problem with the safety device. * Loop detectors: Any that are activated can hold the gate open, indicating a problem with the loop detector or ground loop. The operator may also be in a 'soft shutdown' state. Try activating any keying device to see if the operator returns to normal operation. If you want automatic closing, make sure switch 4 on SW1 is ON.
S
Steven GordonAug 21, 2025
Why does my DKS 6002 Gate Opener start to close, then reverse to open?
- D
  David MeyerAug 21, 2025
  If your DKS Gate Opener starts to close and then reverses to open, here's what to check: * Disconnect the gate from the actuator and ensure it operates freely without any binding. * Check the loop detector LEDs and input LEDs. Any that flash ON will cause the gate to reverse. * If a shadow loop is used, verify proper wiring. A mis-wired shadow loop detector will cause the gate to reverse. If these steps don't resolve the issue, consider replacing the circuit board.
W
Wanda HayesAug 27, 2025
What to do if DKS Gate Opener opens a short distance, then stops and reverses?
- B
  Brian YoungAug 27, 2025
  If your DKS Gate Opener opens a short distance, then stops and reverses, try the following: * Disconnect the gate from the actuator and check that the gate swings freely without any binding. * Check the reverse sensitivity. * Check the secondary safety devices. If the problem persists, replace the circuit board.
M
michael87Aug 30, 2025
Why does my DKS 6002 Gate Opener close and open continuously?
- F
  Francisco RiggsAug 31, 2025
  If your DKS Gate Opener closes and opens continuously, check the following: * Check for any input or loop detector LEDs that are ON. * Verify that the operator is running in the proper direction (refer to the 'gate closes but will not open' information). * Check the SELF TEST jumper.
N
Nicole JohnsSep 6, 2025
How to troubleshoot a DKS 6002 Gate Opener actuator that won't run and the power LED is OFF?
- M
  Melinda MercerSep 7, 2025
  If the actuator(s) of your DKS Gate Opener will not run and the power LED is OFF, check the following: * Ensure that power to the operator is turned ON. * Check for 24 VAC at terminals 19 and 20. If the voltage measures OK, check the terminal strip or replace the circuit board.
L
Lisa MendozaSep 9, 2025
What does it mean if my DKS 6002 alarm sounds for 5 minutes and then beeps once every 5 seconds, and the operator won't run?
- J
  Jordan DeanSep 10, 2025
  The DKS Gate Opener is in a 'hard shutdown' condition. The reset switch must be activated to return the operator to normal operation.