0317 © 2005 Digital Monitoring
New Feature Available for Purchase
Service User Authentication – Feature Key 105
The XR500 Series panel now offers the ability to authenticate service personnel with the SCS-1R
receiver before allowing access to panel programming or performing any user operations.
SVC USER AUTH
Service User Authentication
DISABLED
This feature offers the ability to authenticate service personnel before
allowing access to panel programming or performing any user operations.
When this feature is enabled and a valid Service User code is entered for
system operation or 6653 is entered for programming, the Service Code entry
option displays.
SVC CODE:
When the service person enters the Service Code, the panel authenticates the
code with the Service Code preprogrammed in the SCS-1R receiver, and access
to panel programming or the User Menu is granted. The Service Code can be
used for system operation for 30 minutes before authenticating again. If the
code entered is not validated, access to programming or the User Menu using
the Service User code is denied.
Note: The Service User code is user number zero (0) and can only be created
in the panel remotely.
Note: The SCS-1R receiver must have firmware version 902 or higher to
authenticate service personnel.
Purchasing Feature Upgrades
To purchase a feature upgrade, you may contact DMP Customer Service with the feature you would like
to enable and the panel serial number. The serial number(s) should be sent in writing via e-mail or fax.
A separate feature key is issued for each panel. The feature key only enables the requested feature on
the specified panel.
The panel serial number can be located in several different ways:
Printed on a label located on the right side of the XR500 PCB.
Using panel diagnostics. See the Appendix in the XR500 Series Programming Guide (LT-0679).
Using Remote Link (version 1.18 or higher)
— Initial panel connection screen displays panel serial number when you connect.
— New System Information screen displays all enabled panel features.
— The Panel>Feature Upgrade screen displays panel model, enabled panel
features, and panel serial number.
Ordering the New Software
XR500 Series software update version 108 (3/1/05) is available for download free of charge on the DMP
Dealer Direct Website at http://dmp.com/dealer.
Note: Remote Link Version 1.22 or higher is required to support the panel version 108 features. Remote
Link Version 1.22 is available for download free of charge on the DMP Dealer Direct Website at
http://dmp.com/dealer.
To Previous Page
Loading...
Need help?
General
