Digital Monitoring Products | XTLtouch Installation Guide 15
ADDITIONAL INFORMATION
SECONDARY POWER SUPPLY
The XTLtouch’s 2400mAh rechargeable standby battery is used to provide four
hours of battery power when DC power is not available. The battery is intended
for back power only and should not operate the panel on a daily basis.
If the battery is low or not plugged in to the battery connector, a low battery
condition is indicated by the panel. If a 24 hour standby battery is needed,
connect a 4800mAh battery.
Replace the Battery
1. Remove the backplate from the XTLtouch.
2. Unplug the battery from the BAT connector and remove it from the PCB.
3. Place the new battery in the same location and secure it with the included
adhesive.
4. Re-plug the BAT connector.
5. Replace the backplate. See Figure 12.
Figure 11: Placing the XTLtouch
To Next Page
Loading...
