DMSI 10 - Installation

www.dmsimfg.com
You can also nd the manual online at:
www.dmsimfg.com/StandAloneManual
NETWORK CONNECTION
Installation
1. Turn on the power supply of the converter.
2. ConnectlocalRXtoremoteTXviaopticalberwhenlocalFPL
indicator lights up.
3. Connect local TX to remote RX when both local and remote
FRX, and FPL indicators light up.
4. Ifitsasingle-berconverter,connecttheopticalber.
5. Turn on the power supply of the connected Ethernet devices.
6. Installation is completed.