(No.HD003<Rev.004>)1-35
5.1.16 MG Mechanical AB
• An error has occurred in the mechanical component of the
magnetic encoder.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.17 MG Hardware AC
• A hardware failure has occurred on the magnetic encoder.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.18 Cam Error C1
• A heating roller operation error has occurred.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.19 HR Overheat C2
• The temperature of the bend remedy heating roller or retrans-
fer heating roller is too high.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.20 Hardware D8
• A hardware error has occurred during initialization.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.21 TR Overheat F0
• The temperature of the retransfer heating roller is too high.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.22 TR Heater F1
• The retransfer heating roller is faulty.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.23 TR Thermister F2
• The retransfer heating roller thermistor is faulty.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.24 RR Overheat F3
• The temperature of the bend remedy heating roller is too high.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.25 RR Heater F4
• The bend remedy unit is faulty.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.26 RR Thermister F5
• The bend remedy heating roller thermistor is faulty.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.27 Overcool F6
• The operating ambient temperature of the printer is too low.
Check the temperature. If the same problem recurs within the
range of operating ambient temperature, turn off the power and
consult our authorized dealers.
5.1.28 Head Overheat F8
• The temperature of the thermal head is too high.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
5.1.29 Power Intrpt C3
• An instantaneous interruption is detected.
Turn off and on the power again. If the same problem recurs,
turn off the power and consult our authorized dealers.
MG Mechanical AB
MG Hardware AC
Cam Error C1
HR Overheat C2
Hardware D8
TR Overheat F0
TR heater F1
TR Thermister F2
RR Overheat F3
RR Heater F4
RR Thermister F5
Overcool F6
Head Overheat F8
Power Intrpt C3
To Next Page
Loading...
