- 22 -
English
Getting started
Insert Batteries
Insert the batteries into a battery box in the grip.
Remove the screw using a screwdriver on the lower side of the grip.
On delivery the screw is in a bag inside the equipment.
Slide the cover in the direction of the arrow.
Remove the battery compartment.
Insert four new batteries(included) into the slots of the battery compartment.
The proper orientation of the batteries is indicated on the compartment.
Install the battery cap into place.
Always exchange a complete set of new batteries.
Installing the imager head cable
To use the Findoo the imager head cable must be connected to the hand grip. Be sure that the key and slot
are properly aligned. Once they are aligned, finger tighten the knurled knob to hold the connection in place.
Key Slot
knurled knob
FindooMicroCamDEFN.indd 22 01.11.2010 14:03:41
To Next Page
Loading...