TEST ACTION APPLICABILITY
5 Turn the ignition off.
Remove the Radiator Fan Relay from the PDC.
Disconnect the Radiator Fan harness connector.
Measure the resistance of the Radiator Fan Relay Output circuit between the PDC
and the Radiator Fan harness connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Radiator Fan Relay.
Perform POWERTRAIN VERIFICATION TEST VER-2-NGC.
No → Repair the Radiator Fan Relay Output circuit for an open.
Perform POWERTRAIN VERIFICATION TEST VER-2-NGC.
299
DRIVEABILITY - NGC
*CHECKING RADIATOR FAN RELAY OUTPUT — Continued
To Next Page
Loading...
