Dogtra IQ PLUS+ - Code Setting; 1-Dog code pairing

1818
Warning
1. Fully charge the unit before using it for
WKH¿UVWWLPH
2. Do not charge the batteries near any
ÀDPPDEOHVXEVWDQFHV
3. Fully charge the batteries if the unit is
to be stored without use for a period of
one month or more.
4. Always use iQ Pet approved chargers.
If improper chargers are used, the LED
ZLOOÀDVKLQDPEHURUPD\QRWOLJKWXS
at all.
7. Charging the battery
8. Code Setting
1-Dog code setting
1. Start with the receiver/collar turned off
and the Rheostat intensity dial level on
the handheld transmitter set to “0”.
On the handheld transmitter, slide the
dog selector switch left to align with “I”.
2. Place the red dot on the back of the
handheld transmitter to the red dot on
the receiver/collar. Hold the two red
dots together for 5 seconds.
Release them when the green LED
blinks rapidly on the receiver/collar.