13
Follow the steps below to charge your system:
1. Open the rubber plug on the battery charging
receptacle and plug in the charging cable.
2. Plug the charger into a 120 volt wall outlet or, if using
the auto charger, plug into a cigarette lighter for lithium
polymer batteries. All indicator lights should glow red
when properly plugged in and the unit will automatically
shut off during the charging process.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging the unit, cover the battery charging
receptacle with the rubber plug on the receiver.
To Next Page
Loading...
