9
OPERATING MODES
1. HPP (High Performance Pager) Vibration - (P)
- The YS600 will vibrate twice when your dog barks. No
stimulation will be activated when set to “P”.
2. Stimulation Levels (1-10)
- The YS600 will vibrate once followed by a stimulation
when your dog barks.
* There is a 15 second safety delay between the
stimulation on levels 1-10 and vibration on P mode.
Battery life
LED window
Full charge Medium charge Needs charge
In Use Green Amber Red
Charging Green Red Red
The LED indicator will flash for 1 second when the YS600
has been turned on and every 4 seconds afterwards. If
your dog does not bark for over 30 seconds, the LED
indicator will turn off and the YS600 will go into a sleep
mode to conserve battery life. It will reactivate when your
dog barks and a vibration/correction needs to be made.
Before going into sleep mode, the LED light flashes green
when the battery is fully charged and turns to amber
when the battery life is getting low. When the LED
indicator emits a blinking red light, the battery needs to
be recharged.
LED INDICATOR
To Next Page
Loading...
