78 Dolby
®
Digital Cinema System Manual Issue 0.92 (Preliminary)
Appendix A
A.1.3 DSS220 and Show Manager Login Utilities
The DSS220 provides various utilities that you can access using special login names. Access
a login prompt by typing <Ctrl> + <Alt> + <F1> (<F2>, <F3>, and <F4> also provide login
consoles), then enter the password
dolby.
Config
When you type config at the login prompt and enter dolby at the password prompt, this
utility provides numerous configuration options, including:
• Auditorium number
• Show Manager Server configuration (local or remote)
• Presence or absence of NA10 and DFC100 devices
• Network IP addresses of DSS220 interfaces and auditorium devices (DSS220,
projector, CP650, and so on)
• Keyboard language
• Advanced options
• System name
• Maximum transmission unit (MTU) for auditorium and theatre networks
• Interface on which Simple Network Management Protocol (SNMP) is presented
Unconfig
When you type unconfig at the login prompt and enter dolby at the password prompt,
this utility allows the resetting of network configurations, deletion of all content, resetting
of parameters, or (if applicable) resetting the Show Manager Server database (shows and
schedules).
Serial
When you type serial at the login prompt and enter dolby at the password prompt, this
utility enables you to export the serial automation configuration of one auditorium to a text
file on a USB drive or import a previously exported configuration file. You must run this
utility on the system where the Show Manager Server is running. In a DSL100 network, this
must be the DSL100.
This utility also allows you to export the serial automation configuration from one
stand-alone system and import it to another stand-alone system.
To Next Page
Loading...