9
To meet the applicable safety provisions, only the tool/protector combinations
as indicated in the table must be used.
Be sure to use genuine DOLMAR nylon cutting head.
– If the nylon cutting head hits against a stone during operation, stop the
engine and check the nylon cutting head immediately.
CAUTION: The appropriate protector must always be installed, for your own
safety and in order to comply with accident-prevention regula-
tions.
Operation of the equipment without the guard being in place is not
permitted.
–Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
–When using the string head, fit the protector (6) into the protector (1), and
tighten them with two nuts (5) and two screws (4).
MOUNTING OF PROTECTOR
Protector for cord cutter
Nylon cutting head
To Next Page
Loading...
