To Next Page

To Previous Page

“Heat Pump” - Heat Pump Mode (Select Models)

In the Heat Pump mode the system will cycle the compressor On

and Off based on the room air temperature and the temperature set-

point on the Single Zone LCD thermostat. When the system calls for

heating there will be a delay of approximately two minutes. In auto

fan,thecompressorwillturnOnrstfollowedbythefaninapproxi-

mately 15 seconds. In this mode there are 3 fan speed selections:

Lo - (LOW): The fan operates continuously at low speed. The com-

pressor cycles ON and OFF.

Hi - (HIGH): The fan operates continuously at high speed. The com-

pressor cycles ON and OFF.

Au - (AUTO): When auto fan is selected the fan speed will vary

depending on the difference between the temperature set-point and

the room temperature. In auto fan the compressor and fan will cycle

OnandOffwiththethermostat.Thecompressorshutsoffrstfol-

lowed by the fan in approximately 15 seconds. See “Special Fea-

tures” on page 11 for information on auto fan.

“Heat Strip” - Heat Strip Mode (Select Models)

In the Heat Strip mode the system will cycle the heat strip On and

Off based on the room air temperature and the temperature set-

point on the Single Zone LCD thermostat. In this mode there are 3

fan speed selections:

Lo - (LOW): The fan operates continuously at low speed. The heat

strip cycles On and Off.

Hi - (HIGH): The fan operates continuously at high speed. The heat

strip cycles On and Off.

Au - (AUTO): The fan operates in low speed and will cycle On and

Off with the thermostat.

“Fan” - Fan Mode

In Fan mode there are 3 fan speed selections:

Lo - (LOW): The fan operates continuously at low speed.

Hi - (HIGH): The fan operates continuously at high speed.

Au - (AUTO): The fan will be Off.

Dometic 3313192 Series User Manual

Questions and Answers: