ACX3 Technical description
19
5.2 Control elements
When the cooler is connected to the AC mains, the required cooling level is set using
the cooling level controller for AC operation (1).
➤ To increase the cooling level, turn the cooling level controller (1) clockwise.
For the maximum cooling level, turn the cooling level controller (1) clockwise as
far as it will go.
➤ To decrease the cooling level, turn the cooling level controller (1) anticlockwise.
➤ To switch the cooler off, turn the cooling level controller (1) anticlockwise as far as
it will go.
When the cooler is connected to the DC power socket the cooling level cannot be
adjusted.
When the cooler is operated with gas, the required cooling level is set using the
cooling level controller for gas operation (2).
➤ To increase the cooling level, turn the cooling level controller (2) clockwise.
For the maximum cooling level, turn the cooling level controller (2) to the
maximum position.
➤ To decrease the cooling level, turn the cooling level controller (2) anticlock-
wise.
➤ To switch the cooler off, turn the cooling level controller (2) anticlockwise as far
as it will go .
No. in
fig. 4, page 4,
fig. 5, page 5
Description
1 Cooling level controller (AC operation)
2 Cooling level controller (gas operation)
3 Ignition button
DometicACX3_30-ACX3_40-ACX3_40G_OPM_4445103211 _EMEA16_202x-xx-xx.book Seite 19 Montag, 16. November 2020 9:58 09
To Next Page
Loading...
Need help?
General
