ACX3 Cleaning and maintenance
25
6.10 Defrosting the cooler
A
I
➤ Disconnect the voltage and gas supply.
➤ Empty the cooler.
➤ Put a cloth in the cooler to absorb any excess water.
➤ Leave the lid open.
➤ Wipe the coolerdry with a cloth.
7 Cleaning and maintenance
A
➤ Occasionally clean the product with a damp cloth.
7.1 Cleaning the gas burner
!
I
NOTICE!
Never use mechanical tools to remove ice or to loosen objects stuck to
the device.
NOTE
Over time, frost builds up on the cooling fins inside the cooler. If this
layer of frost is about 3 mm thick, you should defrost the cooler.
NOTICE! Damage hazard
Do not use sharp or hard objects or cleaning agents for cleaning as these
may damage the product.
WARNING!
• Work on gas installations may only be performed by qualified
technicians.
• Allow the burner to cool down before cleaning it.
NOTE
• Dirt in the gas burner is indicated by poor ignition or deflagrations.
• The manufacturer also recommends cleaning the burner after it has
not been used for an extended period, and at least once a year.
DometicACX3_30-ACX3_40-ACX3_40G_OPM_4445103211 _EMEA16_202x-xx-xx.book Seite 25 Montag, 16. November 2020 9:58 09
To Next Page
Loading...
Need help?
General
