To Next PageTo Next Page
Need help?Do you have a question about the Dometic CAL136.302 and is the answer not in the manual?
General| Brand | Dometic |
|---|---|
| Model | CAL136.302 |
| Category | Air Conditioner |
| Language | English |
Unit must be serviced by authorized personnel; modifications are hazardous.
Manufacturer not liable for damages from improper installation or operation.
Cut through roof and ceiling for unit installation.
Requires 220-240V, 50 Hz, 10 Amp wiring.
Power must be above 209V and frequency must be 50 Hz.
Details model, capacity, electrical ratings, and wire size.
Installation must comply with codes; no unauthorized modifications.
Guidelines for positioning one or more units on the caravan roof.
Checks for existing openings and suitability for modification.
Acceptable roof pitch and leveling requirements for installation.
Disconnect all power before cutting to prevent shock hazard.
Steps to remove existing vents and prepare openings.
Procedures for marking, cutting, and sealing new openings.
Warning about electrical wiring between roof and ceiling during cutting.
Procedures for adjusting opening size if needed.
Routing the grounded power supply line to the opening.
Installing wood framing around the opening for support and sealing.
Instructions for lifting and placing the air conditioner unit.
Installing the upper discharge air duct over the blower opening.
Attaching the ceiling template and securing the unit with bolts.
Torqueing mounting bolts and ensuring gasket compression for a water seal.
Warning against over-tightening mounting bolts to prevent damage.
Ensure power is OFF before connecting leads to the unit.
Connecting power via permanent connection or plug-in, and terminal block details.
Installing the heat package to the ceiling template and connecting its plug.
Installing the air box, grills, filters, and knobs.
Unit is ready for operation after installation; read instructions.
Explains thermostat and selector switch functions for modes and speeds.
Setting the thermostat and selector switch for cooling.
Selecting fan speeds for air circulation without heating or cooling.
How the compressor and blower cycle to maintain temperature.
Heater is for removing chill, not primary heating.
Setting thermostat and selector switch for heating operation.
Procedure for turning off the unit and required delay before restart.
Periodic cleaning of return air filters.
Causes of frost and methods to prevent or clear it.
Checks for power, wiring, and fuses before calling service.
Details needed when contacting service personnel.
