Installing and connecting the cooling device CB, RHD
10
7 Installing and connecting the cooling
device
7.1 Installing the cooling device
The device is designed for ambient temperatures between –10 °C and +32 °C. In
continuous operation, the air humidity may not exceed 90 %.
Install the cooling device in a dry, sheltered place (installation dimensions: fig. 1 to
fig. 3, page 3). Avoid installing the devices next to heat sources such as heaters,
gas ovens, hot water pipes, etc.
The cooling device must be installed so that heated air from the cooling unit can
dissipate easily. Therefore make sure there is adequate ventilation.
On the CoolMatic CB36, CB40 and RHD50 devices, the cooling unit is removable
and can be mounted at a distance of up to 1.5 m (CB36, CB40, RHD50) away from
the cooler if space is limited.
7.2 Adapting the decor (only CB36, CB40)
The lids of the devices can be adapted to match the decor of the surroundings.
7.3 Connecting the cooling device
Connecting to a battery
The cooling device can be operated with a 12 V to 24 V DC voltage supply.
A
NOTICE!
To avoid voltage loss and therefore a drop in performance, the cable
should be kept as short as possible and should not be interrupted if this
is possible.
For this reason avoid additional switches, plugs or power strips.
RHD-CB--O-West.book Seite 10 Dienstag, 29. November 2016 11:52 11
To Next Page
Loading...
Need help?
General
